tenons, and, by placing them against the posts in
the exact position they are to occupy, mark the places for the mortises.
These joints should be numbered so that each mortise may be cut to fit
its own tenon.

[Illustration: Detail of Construction Finished Table]

Square up the slats, 3 by 15-1/8 in., and cut mortises in the upper and
lower rails 1/4 in. deep to let them in. The number of these slats,
their size and spacing may be arranged to suit one's own idea. Put the
posts, upper and lower rails, and slats together without glue first to
determine if the parts fit properly, and then glue and clamp them
together. Hot glue will hold best, if the room and lumber are warm; if
not, it is best to use ordinary liquid glue. While the glue on these two
ends of the table is setting, the other upper rails, top, and stretcher
may be finished.

The top will have to be made of two or three pieces joined together with
dowels and glue. If possible, use only two boards and be sure the grain
in both pieces runs the same way when they are put together.

After the ends which were glued have set at least 24 hours, the clamps
may be taken off and the other two upper rails tenoned and mortised in
place. The stretcher may be held with two 3/8-in. dowels in each end, or
with two round-head screws put through the lower rails. When gluing up
the whole table, be sure the sides are square to each other. The top may
now be squared up 24 by 24 in. and the corners cut out for the top of
the posts. The top may be fastened as shown at A and B in the drawing,
or by cleats screwed to the inside of the upper rails and top.

Before staining, be sure that all surplus glue is scraped off and the
surfaces sanded clean. A weathered or fumed oak stain is suitable for
this table. A good weathered oak stain may be made by mixing a little
drop black ground in oil with turpentine and a little linseed oil. Put
this stain on with a brush and allow to stand until it begins to
flatten or dull, then rub off across the grain with a rag or piece of
cotton waste. When thoroughly dry, apply one coat of very thin shellac.
After this has dried, finish with two coats of wax. The shellac prevents
the turpentine in the wax from rubbing out the stain. To get a good wax
finish the work should dry until it will not show finger marks, before
rubbing.

BOOK TROUGH

[Illustration: Detail of Book Trough]

A very cheap but attractive book trough is shown in the accom