ores of the wood with a black paste
filler--directions will be found on the can. Follow this, when hardened,
with several coats of floor wax.
A PEDESTAL
The pedestal shown in the accompanying illustration is another piece of
furniture that can be made in the mission style. It is very simple in
design and construction, and can be made by anyone who has a few simple
tools and a slight knowledge of their use. It is best to make it of
quarter-sawed oak as this is the most easily procured wood and also
looks the best when finished. If you order the material from the mill
ready cut to length, squared and sanded, much hard labor will be saved.
Following is a list of the material needed:
1 top, 3/4 by 12 by 12 in., S-1-S.
1 bottom, 3/4 by 12 by 12 in., S-1-S
8 pieces, 3/4 by 2 by 11 in.
2 sides, 3/4 by 5 by 26 in., S-1-S.
2 sides, 3/4 by 3-1/2 by 26 in.
1 piece, 3/4 by 6 by 6 in.
4 blocks, 1 in. square.
[Illustration: Completed Pedestal]
Having the boards for the post cut to the proper length and square, nail
them together as shown in the detail drawing. Use finishing nails, then
set the heads and fill the holes with putty. Next, nail the 3/4 by 6-in.
piece on one end of the post leaving the edges projecting even on all
sides. Pick out the best board for the top. On the under side and 1/2.
in. in from the edges, nail four of the 3/4 by 2 by 11-in. pieces which
have been previously mitered as shown in the plan view. Now fasten this
top to the post by nailing through the projecting edge of the top piece
into the top board. Be careful to get this top on square with the post
and exactly in center.
The bottom board is made in the same manner as the top board and is
nailed to the lower end of the post as shown. Four 1-in. square blocks
should be fastened to the bottom for the pedestal to rest on.
When complete, sandpaper smooth and apply any one of the many mission
stains that are supplied by the trade for this purpose.
[Illustration]
After staining the wood, the surface can be given a polished or dull
finish, as desired. Mission furniture requires a dull finish, and this
may be obtained by applying a coat of wax, well rubbed on the wood.
MAGAZINE RACK
The accompanying cut shows a magazine rack that will find favor with
many amateur wood-workers on account of its simplicity in design and its
rich, massive appearance when properly finished. It is so constructed
that each piece
|