t be nailed to them,
because this would cause the drawer to stick, when the bottom expands.

Metal rings or wooden knobs will do well for the drawer pulls.

Stain to any desired shade and finish with a wax if a dull gloss is
wanted, or with one coat of shellac and two coats of varnish for a
highly polished surface.

A SIDE CHAIR

A companion piece to the chair with arms and the sideboard is the side
chair illustrated herewith. It should be made of the same kind of wood
and finished to correspond with the armchair. Order the following stock
list:

2 front posts, 1-1/2 by 1-1/2 by 18-1/2 in., S-4-S.
1 piece for back posts, 1-1/2 by 5-1/2 by 38-1/2 in., S-2-S.
4 seat rails, 1 by 2 by 17 in., S-4-S.
4 lower side rails, 5/8 by 1-1/4 by 17 in., S-4-S.
2 lower front and back rails, 5/8 by 2-1/2 by 17 in., S-4-S.
1 back rail, 3/4 by 2-1/4 by 17 in., S-4-S.
1 back rail, 3/4 by 2 by 17 in., S-4-S.
1 slat, 3/8 by 3 by 13-1/2 in., S-4-S.
2 slats, 3/8 by 1-1/2 by 13-1/2 in., S-4-S.

Square up the front posts to length. From the single piece specified cut
out the back posts, giving them the amount of slant indicated in the
drawing. Set these four posts upright in the positions they are to
occupy relative to one another in the finished piece, and mark off, as
with penciled circles, the approximate locations of mortises. After
this, lay them on the bench side by side, even the lower ends and locate
accurately the ends of the mortises. Gauge their sides.

Saw the rails to length and lay out the shoulder lines and the cheeks of
the tenons and cut them. Plan to house the ends of the slats in the back
rails.

[Illustration: Side Chair of Dining-Room Set]

While the drawing shows a chair in which the front and back are of equal
width, the amateur may make the back narrower if he so desires. A
measurement of a common chair will give the proportions.

[Illustration: Detail of the Side Chair]

Place the front and the back in the clamps and after the glue has had
time to harden, assemble the remaining parts. Thoroughly scrape and
sandpaper all the parts, carefully removing any surplus glue. Wood
finish will not "take hold" where any glue has been allowed to remain.

The seat may be given the same treatment as suggested for the armchair.
This should not be done, however, until the finish has been applied.

A simple finish is obtained by the application of a coat of paste filler
of a soft brown color, i