hard. It is a good one to use in
staking off the garden. It is entirely a piece of knife work. The
dimensions are clearly given on the working plan. If the stake is made
12 inches instead of 14 inches, it may be used as a foot rule in
measuring off furrows.
[Illustration: A heavy stake like this one, Jack used in marking off
his drills. It is adapted to just such work.]
THE BOY'S GARDEN REEL
A piece of wood (ash is suitable for this work), 11-3/8 x 4-1/2 x 1/2
in. is needed. Draw pencil lines lengthwise and widthwise through the
centre of this piece. From the centre measure out one inch in both
directions, placing dots. These give the central points for centre cut.
Measure from the four corners of the piece 3 inches along the length.
Connect by line the opposite dots. This gives the line marked 4-1/2 in.
in the diagram. It shows the beginning of the cut to the centre line.
One inch above these lines draw other lines straight across the wood.
Find centre of these. Place a dot one-half inch on both sides of each
from centre. This gives the one-inch end cuts. Cut this up to one-half
inch of each corner. This makes a large substantial garden reel.
[Illustration: Made of hard wood this reel will last forever.]
A PLANT STOOL OR TABOURET
The materials needed are four pieces 18 x 3 x 7/8 in. planed, for legs;
one piece 14 x 14 x 7/8 in., planed, top; two pieces 8-1/2 x 1-3/4 x 7/8
in., planed, lower braces; one piece 8-1/2 x 8-1/2 x 7/8 in., planed,
upper brace. Use chestnut, white wood, white oak, mahogany, cherry or
birch. You will need also 2-in. blued screws, round head, for
fastenings.
[Illustration: This looks like a pretentious piece of woodwork for a lad
to make. George did not think so. The construction is simple. Note the
good lines.]
To construct the stool make with the two 8-1/2 x 1-3/4 x 7/8 in. pieces
the lower braces, a lap joint. Find the mid-line of each piece by
measuring 4-1/4 in. from the ends. From this line lay off two other
lines parallel to it and at a distance of 7/8 in. to the right and
left. This makes a 1-3/4 in. square in the centre of each piece. Now
transfer these lines down the edges of the lower brace pieces. Saw on
the inside of the lines down one-half the thickness or saw and chisel
down to one-half. It is necessary to saw on the inside of the lines or a
loose joint will result. The joint must be exactly in the middle and all
arms must be equal in length when completed. Bra
|