ushed down
inside the basket on one side of the handle and over again on the other
side of the handle, three rows from the top, making a loop inside. The
weaver is then laid close beside the first twist and follows it across
to the opposite side. Now it goes in under the third row on the left of
the handle and out on the right side. Each row of twisting must follow
close beside the last. Six or seven rows will cover the foundation. The
end is fastened off by bringing it inside the basket again where it is
cut off.
This flower basket may be made without the handles. But they add much to
it without being a great deal of extra work.
A SUNDIAL
Take two pieces of the wood you have chosen:
A, 6-1/2 x 6-1/2 x 1/4 in. and B, 7 x 7-1/2 x 1/4 in.
_Construction_.--True up each piece to the given dimensions, and
sandpaper carefully. Be careful to stroke the wood always with the
grain--never across the fibres.
[Illustration: Dee's sundial kept fairly accurate time. It is a real
ornament to the garden.]
[Illustration: Gnomon pattern just one-half actual size]
Next make a shadow-piece, or gnomon, as it is called. Get a thin piece
of the same kind of wood as is used in piece A, and lay it out as
follows: With the fibres running in the direction AB, beginning at
point A construct an angle equal to the latitude of the place where the
dial is to be used. For example, if the latitude of a town is 41 degrees
construct the angle D 41 degrees, or if it is 42 degrees, let D be 42
degrees. Then cut from A to C, and sandpaper carefully. Take the wooden
shadow-piece and fasten it to the centre of piece A. Fasten by two brads
or small nails about 3/4 inch or 1 inch long, or glue it. Place piece A
over piece B so that a margin of 1/4 in. will be left on all sides.
Place A so that the fibres will run at right angles to B to prevent the
boards from warping. These two pieces may be fastened together by
driving a brad in each corner, or gluing, or both.
POT-REST
Use almost any kind of wood, as white wood, cherry or white oak.
Two pieces of wood 8 x 1/2 x 1-1/2 in. are needed for the cross pieces.
These should be planed. There are needed also four little pieces as feet
or pads. The dimensions of these should be 1-1/2 x 1-1/2 x 1/2 in.
To make this stand, draw a line across the two long pieces 4 inches
from either end. Lay off two other lines parallel to this 5/8 inch to
the right and left. Transfer these lines down the edges
|