1. Insert control cables in their respective bushings on the case
(volume control is upper bushing when receiver is installed in the car),
until they seat themselves and then tighten the set screws.

2. Turn the station selector knob to the right (clockwise) until it
stops--then turn the knob counter-clockwise until it stops. The dial is
now logged.

3. Turn the volume control knob clockwise until the knob turns hard. The
volume control is now on full.

=Eliminating Motor Interference--=

Connect the ammeter condenser to the spring clip at the end of the wire
containing the fuse holder by means of the self-threading screw on the
side of the spring clip. Ground the other terminal of the condenser at
any convenient point.

Install the generator condenser on the generator side of the generator
cut-out as shown in the Diagram of Connections. DO NOT connect the
flexible lead to the field terminal of the generator.

Remove the center distributor lead and insert the distributor suppressor
in its place. Then plug the distributor lead into the suppressor.

=Adjusting Delco Syncro-Tuning--=

Turn the receiver on.

Tune-in a radio station which logs between 55 and 65 on the dial and
gives the radio a signal BARELY AUDIBLE in the speaker WITH the VOLUME
control FULL ON. A small snap button cap is located in the end of the
receiver case beside the antenna lead connection. Remove the snap button
cap by prying with a small screw driver.

By means of a small screw driver inserted in the hole which was covered
by the small cap, adjust the Delco Syncro-Tuning condenser unit for
maximum output in the speaker. Remaining on same station, readjust
station selector for maximum volume and readjust the Delco Syncro-Tuning
Condenser unit for maximum output. No further adjustment of this unit
will be necessary as the receiver is now adjusted for best operation
with your car antenna. Replace the snap button cap.

OPERATION

=To Turn On Receiver--=

Some control units have a small knob located below the center of the
dial. If your receiver is equipped with this type of control push this
small knob in as far as it will go. Other control units have a
combination on-off switch and volume control knob. To turn on this type
of control turn the knob clockwise until the switch clicks and the dial
is illuminated.

=Volume Control--=

Turning the volume control knob toward the right increases the output of
the receiver an