stributor Suppressor 1207818

1 Generator Condenser 1849014

1 Ammeter Condenser 1209333

INSTALLATION

=Antenna--=

See Instructions in antenna package.

=Chassis--=

This receiver may be installed on any car with Positive or Negative
ground without any changes of wiring.

When possible, locate the chassis on the driver's side of the dash, over
the steering column, with the removable cover plate facing the floor.
This position places the control shafts on the end of the case facing
the center of the car.

Locate the position of the mounting holes by means of the template
included in the package. Drill the holes, using a 3/8" drill, and scrape
the paint from around the holes on the engine side of the dash to insure
a good ground connection as there is no other ground connection for this
receiver.

Make sure that all tubes and the vibrator are pushed well down in their
sockets and that all the grid clips are properly in place on the top
caps of their respective tubes.

If a six-volt storage battery is available, check the receiver for
normal operation before permanently installing it on the car. The
antenna lead and control unit may be temporarily connected for this
test.

Insert the two receiver mounting studs in the back of the receiver case
with the "burred" threads nearest the receiver to make sure that these
studs do not enter the case far enough to cause damage to the receiver
parts.

Install the receiver, using the drilling template as a spacer between
the dash and the receiver case. Install the two shakeproof washers over
the chassis mounting studs. Then tighten the mounting nuts to insure
that the receiver case shall be thoroughly grounded to the dash.

=Antenna Lead--=

Attach the black antenna lead to the car antenna and plug the connector
on the antenna lead into the receiver chassis as shown in the
Installation Diagrams. Ground the pigtail of the antenna lead shield to
a convenient body bolt. Keep antenna lead out of engine compartment to
avoid possibility of ignition interference being picked up by the
lead-in.

=Speaker--=

See Instructions in speaker package.

=Remote Control Unit--=

See Instructions in remote control package.

CONTROL UNIT ADJUSTMENT

The volume control and station selector shafts are AUTOMATICALLY
adjusted as follows: