ination shall disclose to its satisfaction to
have been thus defective; this warranty being expressly in lieu of all
other warranties expressed or implied and of all other obligations or
liabilities on its part, and the manufacturer neither assumes nor
authorizes any other person to assume for it any other liability in
connection with the sale of its products."

"This warranty shall not apply to any radio receiving set which shall
have been repaired or altered outside manufacturer's authorized Service
Stations in any way so as in the judgment of the manufacturer to affect
its stability, or on parts not made or authorized by the manufacturer
have been used for replacement or other purposes, nor which has been
subject to misuse, negligence, or accident."

UNITED MOTORS SERVICE, INC.

DETROIT, MICH.

Form No. 2095 Printed in U. S. A.

===========================================================================
===========================================================================

Delco

Rebuilt 1 55-D
Delcotron Generator 1845985

Rebuilt by Delco-Remy. Division of General Motors, Anderson, Indiana,
46011
Made in U.S.A. 275829 Printed in U.S.A.

12-17-71 DR-7086

INSTALLING SERVICE DELCOTRON(R) GENERATOR

1. DISCONNECT GROUNDED CABLE FROM BATTERY.

2. If it is necessary to rotate the slip ring end frame to match the
unit being replaced, remove the thru bolts, separate frames just far
enough to rotate to desired position and replace thru bolts.

CAUTION: Separating the end frame too far causes the brushes to drop on
to the greased shaft. If this happens, remove end frame completely,
clean brushes with clean cloth, reassemble springs and brushes retaining
them in position with a pin (toothpick). Remove pin after frames are
reassembled.

WHEN INSTALLING DELCOTRON(R) GENERATOR WITH INTEGRAL REGULATOR, THE SLIP
RING END FRAME MOUNTING BRACKET IS NOT NEEDED.

3. When reusing the original fan, pulley and collar, tighten shaft nut
to 40 to 60 lb. ft. If torque wrench is not available, insert a 5/16"
hex wrench in end of shaft and tighten nut until the spring washer is
just flattened.

4. Install Delcotron(R) Generator and check belt tension, mounting bolt
tightness and make sure all electrical connections are clean and s