|
| AND BY DOING SO THE JACKET WILL BE DAMAGED |
| |
+----------------------------------------------+

_LEVELING UNIT_

In case floor is uneven, unit may easily be made level by inserting
shims under the 4 shipping lugs. These lugs also keep the jacket 1/2"
off the floor, protecting it from wet floors and dampness.

_PIPING AND WIRING_

Once the unit is in its proper location with the packing carton, skids
and packing material removed, it is ready for piping and connection from
Room Thermostat and 110 V. 60 Cy. A.C. Current.

_CONTROL SYSTEM_

The controls furnished are for a one zone Forced Water System consisting
of T87F Room Thermostat, L8124A-1007 Triple Acting Aquastat and
Circulator Relay, C554A-1018 Cadmium Photocell, R8184G-1005 Burner
Relay and V4046A-1009 Oil Valve. Description and complete wiring diagram
will be found packed with each control.

_SPECIAL CONTROL SYSTEMS_

For special control systems such as multiple installations, zone
controlled, unit heater, radiant panel, etc., write to factory for
wiring diagrams.

_CHIMNEY AND BREECHING REQUIREMENTS_

The CP boiler should be connected to a vertical vent system that will
prevent: (1) positive pressure in the flue, (2) backward flow of flue
gas through the unit when the burner stops, and (3) condensation in the
flue.

Use double-walled or insulated pipe for sections of the flue in cold
areas. All outside vents, except for short extensions, must be insulated
to avoid condensation in the flue. Several types of prefabricated
chimneys are available providing double-walled or insulated pipe, some
with ceramic and others with metallic liners.

While the unit is equipped with an induced draft fan, proper size vent
must be provided to remove the gases of combustion. It is recommended
that a 4" to 5" increaser be used for venting the 87CPO and 108CPO and a
4" to 6" increaser be used for the 128CPO. For abnormal runs (exceeding
10 ft.), consult factory.

Vent and breeching must be gas tight by sealing with asbestos or
thermo-setting pressure sensitive tape.

_DRAFT REGULATOR_

It is recommended that a draft regulator be installed in chimney flue
_just below the flue pipe opening_, if the unit is attached to an
extremely high chimney; an unlined chimney; or a chimney which is
constructed on the exterior of the house.

_CONTROLS AND TRIM_

Controls are inst