cork about a quarter
of an inch thick and stick pins closely together all round it, as in
the above picture. Then weave wool in and out of them.

DOLLS' HOUSES AND DOLLS OF CARDBOARD AND PAPER

A cardboard house, furnished with paper furniture and occupied by
paper dolls, is a very good substitute for an ordinary dolls' house,
and the making of it is hardly less interesting. The simplest way to
make a cardboard house is to cut it all (with the exception of the
partition and the roof) in one piece.

The plan given here is for a two-roomed cottage, the measurements for
which can be multiplied to whatever size you like (or whatever is the
utmost that your sheet of cardboard will permit). The actual model
from which this plan was made (the house was built from a royal sheet
of Bristol board) had a total floor measurement of 8 inches by 14. The
end walls were 5 inches high, the side walls 5 inches, sloping up to 7
in the middle, and the partition was 7 inches. The roof was slightly
wider than the floor, in order to make wide eaves, and as much longer
as was needful not only for the eaves but also to allow for the angle.

The first thing to do is to rule the outline of the cottage. All the
measurements must be most accurately made, as the slightest
incorrectness will keep the house from fitting together properly. Then
cut it out. When this is done, draw the windows and doors. Then lay
your cardboard on a board, and run your knife along each side of the
windows and the three free sides of the doors until the card is cut
through. A ruler held close to the penciled line will make your knife
cut straight. The bars across the windows can be made of strips of
paper glued on afterward. If the doors have a tiny piece shaved off
each of the cut sides, they will open and shut easily.

To make the front door open well, outward, the hinge line of the door
(KK) should be half cut through on the inside. The hinge can be
strengthened by gluing a narrow strip of paper or linen along it. At
the three points marked H make small slits through which to put the
tags, marked G, of the partition wall.

All drawing and painting must be done on both sides while the house is
still flat. The doors inside will need handles and keyholes. Small
pieces of mica can be glued over the windows instead of glass.

Little curtains of crinkly tissue-paper can also be made, and, if you
like, the walls can easily be papered with colored pa