her and it
allows the rope to be handled more easily, and to pass around a winch
or to be coiled much more readily, than when other knots are used.

[Illustration: FIG. 29.--Half-hitch and seizing.]

CHAPTER III

TIES AND HITCHES

All the knots I have so far described are used mainly for fastening
the two ends of a rope, or of two ropes, together. Of quite a
different class are the knots used in making a rope fast to a
stationary or solid object, and are known as "hitches" or "ties."

One of the easiest of this class to make and one which is very useful
in fastening a boat or other object where it may be necessary to
release it quickly is the "Lark's Head" (Fig. 30). To make this tie,
pass a bight of your rope through the ring, or other object, to which
you are making fast and then pass a marline-spike, a billet of wood,
or any similar object through the sides of the bight and under or
behind the standing part, as shown in _A_, Fig. 30. The end of the
rope may then be laid over and under the standing part and back over
itself. This knot may be instantly released by merely pulling out the
toggle. Almost as quickly made and unfastened is the "Slippery Hitch"
(Fig. 32). To make this, run the end of the rope through the ring or
eye to which it is being fastened, then back over the standing part
and pull a loop, or bight, back through the "cuckold's neck" thus
formed (Fig. 33). To untie, merely pull on the free end. Two
half-hitches, either around a post or timber or around the standing
part of the rope, make an ideal and quickly tied fastening (Figs. 34
and 35). To make these, pass the end around the post, ring, or other
object, then over and around the standing part between the post and
itself, then under and around the standing part and between its own
loop and the first one formed. After a little practice you can tie
this knot almost instantly and by merely throwing a couple of turns
around a post, two half-hitches may be formed instantly. This knot
will hold forever without loosening, and even on a smooth, round stick
or spar it will stand an enormous strain without slipping. A more
secure knot for this same purpose is the "Clove Hitch" (Fig. 36),
sometimes known as the "Builders' Hitch." To make this, pass the end
of rope around the spar or timber, then over itself; over and around
the spar, and pass the end under itself and between rope and spar, as
shown in the illustration. The Clove hitch with ends kn