tick which rests on the ground, place the end of a third stick
(Fig. 134). Keep on building the first layer of the fence in this way
until it stretches as far as you wish; then go back to the starting
point and begin building the second layer of sticks, by placing a stick
over the first stick, resting one end on the far end of the first stick,
the other end on the top of the end of the second stick; lay another
stick across over the second stick, another over the third, and so on
until the second layer is finished. Build other layers in like manner,
and make the fence high or low, as desired. Pile up kindling wood into a
wood-pile with small pieces scattered on the ground, and if there is a
toy horse you can make him haul more wood (Fig. 132).
These kindling-wood toys will give a realistic idea of log-houses,
rail-fences, log rafts, and primitive bridges, and while building them
the children might be told stories of the way early settlers lived and
made their homes, or the children may "make up" stories about the
different scenes.
=Hammocks=
Substantial little hammocks which will hold good-sized dolls, and even a
real pussy with no danger of the material breaking, can be made of
ordinary kindling wood or strips of pasteboard (Fig. 135). Both styles
of hammocks are woven in the same manner. The weaving is like that used
for the raft and is of the simplest, most primitive kind, merely
crossing of the two ends of each side string between each piece of wood
(or pasteboard) slat, with loops of string left at each end of the
hammock for hanging it up. When fashioned of kindling wood, like that in
the photograph, have the sticks slender and all of the same length. When
made of pasteboard, cut seven-inch-wide strips from a heavy pasteboard
box and cut the strips crosswise into one-half-inch slats. Have ready
two long strings measuring about two and a half yards each. Double each
string and tie a knot in the closed end, fifteen inches from the extreme
folded end, then place your work on the top of the table, or some other
flat surface where you can keep the slats flat and even. Begin to weave
by laying a slat between the loose ends of each string.
[Illustration: FIG. 135--A substantial little hammock.]
Push the slat up tight against the knots and cross the strings on the
outer edge of the slat. Slide another slat between the two ends of each
side string, shoving it close up against the crossed strings at the
outer ed
|