ing mild steel of 0.20 per cent carbon;
(2) case-hardening 3-1/2 per cent nickel steel; (3) case-hardening
nickel-chromium steel; (4) case-hardening chromium vanadium. After
having chosen a suitable steel it is best to have the sample analyzed
by reliable chemists and also to have test pieces machined and pulled.

To prepare samples for analysis place a sheet of paper on the table
of a drilling machine, and with a 3/8-in. diameter drill, machine
a few holes about 3/8 in. deep in various parts of the sample bar,
collecting about 3 oz. of fine drillings free from dust. This can be
placed in a bottle and dispatched to the laboratory with instructions
to search for carbon, silicon, manganese, sulphur, phosphorus and
alloys. The results of the different tests should be carefully
tabulated, and as there would most probably be some variation an
average should be made as a fair basis of each element present,
and the following tables may be used with confidence when deciding
if the material is reliable enough to be used.

TABLE 16.--CASE-HARDENING MILD STEEL OF 0.20 PER CENT CARBON

Carbon 0.15 to 0.25 per cent
Silicon Not over 0.20 per cent
Manganese 0.30 to 0.60 per cent
Sulphur Not over 0.04 per cent
Phosphorus Not over 0.04 per cent

A tension test should register at least 60,000 lb. per square inch.

TABLE 17.--CASE-HARDENING 3-1/2 PER CENT NICKEL STEEL

Carbon 0.12 to 0.20 per cent
Manganese 0.65 per cent
Sulphur Not over 0.045 per cent
Phosphorus Not over 0.04 per cent
Nickel 3.25 to 3.75 per cent

TABLE 18.--CASE-HARDENING NICKEL CHROMIUM STEEL

Carbon 0.15 to 0.25 per cent
Manganese 0.50 to 0.80 per cent
Sulphur Not over 0.045 per cent
Phosphorus Not over 0.04 per cent
Nickel 1 to 1.5 per cent
Chromium 0.45 to 0.75 per cent

TABLE 19.--CASE-HARDENING CHROMIUM VANADIUM STEEL

Carbon Not over 0.25 per cent
Manganese 0.50 to 0.85 per cent
Sulphur Not over 0.04 per cent
Phosphorus Not over 0.04 per cent
Chromium 0.80 to 1.10 per cent
Vanadium Not less than 0.15 per cent

Having determined what is required we now proceed to inquire into
the question of carburizing, which is of vital importance.

USING ILLUMINATING GAS

The choice of a carburizing furnace depends greatly on the facilities
available in the loca