{2x1, " repp.
" 201/4 " 1377 "
23 " (11/2% for shrinkage).
----
Total 1400 dents.

#Drawing-in#--1st edge, 7 dents, 6x2 satin. }
Ground, 34 " 6x1 " }
2 " 6x2 " }
10 " 6x1 " } twice }
2 " 2x1 repp. } over. }
10 " 6x1 satin. }
2 " 6x2 " }
39 " 6x1 " }
5 " 2x1 repp. } twice }
4 " 6x1 satin. } over. } 7 times
5 " 2x1 repp. } over.
15 " 6x1 satin. }
2 " 2x1 repp. }
15 " 6x1 satin. }
5 " 2x1 repp. } twice }
4 " 6x1 satin. } over. }
5 " 2x1 repp. }
5 " 6x1 satin. }
28 " 6x1 " }
2d edge, 7 " 6x2 " }
Satin on 1st section of 8 shaft skip draw.
Binder " 2nd " " 2 "
Repp " 3d " " 2 "

[Page 97]
On each side of every repp stripe two ends of the satin warp must be
entered on the 2 binder shafts (2d section), to prevent the ends of the
satin to slide over into the repp stripes.

#Warping Ticket#--I. _Beam satin_, 106 yards.
1st edge, 42/2 black.
Ground, 204/1 " }
12/2 sky. }
180/1 black. }
12/2 sky. }
234/1 black. }
48/2 sky. } 7 times over.
180/1 black. }
48/2 sky. }
30/1 black. }
168/1 " }
2d edge, 42/2 " }

6132 single ends black.
1680 " " sky.

II. _Beam repp_, 110 yards.
4/1 scarlet. }
4/1 " }
10/1 " }