n the back side so that
it can be readily taken off to get at the clock movement from the front.
Make the doors, tenoning the rails into the stiles and grooving both to
receive the mullioned framework of 3/16-in. stuff.
Put the whole frame together, using good hot glue for the joints. When
the glue has dried sufficiently to allow the clamps to be taken off, fit
the doors and hinge them. Butterfly surface hinges look well and are the
easiest to apply.
Thoroughly scrape all the surplus glue off and sandpaper the parts
preparatory to applying the finish.
To finish, apply one coat of mission oak water stain. When dry,
sandpaper lightly, using No. 00 paper. Apply a second coat, diluted with
an equal amount of water. Sand this lightly and put on a very thin coat
of shellac to keep the filler color, which follows, from discoloring the
high lights. When the shellac has had time to harden, sand lightly and
put on a coat of paste filler. Use light filler, colored with umber and
Venetian red in the proportion of 12 oz, of umber, and 4 oz. of red to
20 lb. of filler. The directions for applying the filler will be found
on the can labels. On the hardened filler apply a thin coat of shellac.
Sand the shellac lightly and put on several coats of some good floor
wax, polishing well according to the directions on the can. This is what
is known as a mission oak finish and is quite popular for this type of
furniture design.
The metal figures for the dial come with the clock movement. Some of the
movements come already set in boxes of wood so that all one needs to do
is to shape the projecting ends of the wood containing boxes and fasten
them to the frame with screws from the back. A clock with dial figures,
eight-day movement, striking the hours and half hours, with cathedral
gong can be bought for $4, possibly less.
A ROCKING CHAIR
In furniture construction such as this, nothing is gained by trying to
plane up the stock out of the rough. This is mere drudgery and can be
more cheaply and easily done at the planing mill by machinery. There
will be plenty to do to cut and fit all the different parts. Order the
pieces mill-planed and sandpapered to the sizes specified below.
Plain sawed red oak takes a mission finish nicely and is appropriate.
Some people like quartered white oak better, however. The cost is about
the same.
The stock for the chair is as follows: Widths and thicknesses are
specified exact except for
|