l suit of clothing for inspections, parades, etc.= Set
aside your best suit of clothes for inspections, parades and other
ceremonies. The uniform worn at these formations should not be worn
around in the barracks,--every man has sufficient "second best"
garments for barrack use.
=1283. Putting away.= Uniforms should be dried thoroughly, brushed and
properly folded before being put away. The number of folds should be
reduced to a minimum.
Before uniforms are put away they should be carefully examined and any
missing buttons, tears or stains should be attended to at once.
Lockers and other places in which clothing is kept must be free from
dust. They should be wiped off occasionally with a cloth wrung out of
soap suds.
=1284. Stains.= Tailors usually remove stains with a rubber made by
rolling tightly a piece of woolen cloth of some kind, about 2 inches
wide, until the roll is about an inch in diameter.
Rings in removing stains may be avoided by rubbing until very nearly
dry.
=1285. Grease spots.= Ordinarily benzine is a good stain remover in
case of grease spots, but its use is more or less dangerous. It should
be used in an open room or out of doors and never near a fire or
lights.
"Carbona," which can be purchased in almost any drug store, is
excellent for removing stains and it is perfectly safe.
Carbon tetrachloride (Merck's) is much cheaper than "Carbona" and
about equally as good. It retails at 45c a pint at nearly all drug
stores.
Grease spots can also be removed by placing a piece of brown paper,
newspaper, blotting paper or other absorbent paper over the stain, and
pressing with a hot iron.
=1286. Rust or ink stains= can be removed with a solution of oxalic
acid. Apply rapidly and rinse at once with plenty of fresh water; this
is most important--otherwise it will probably discolor the material.
=1287. Sweat stains= can not be removed. However, the color can be
partially restored and the material cleaned with a solution of ammonia
and water--1/3 liquid ammonia, 2/3 water.
=1288. The shine= that is sometimes left from pressing is caused by
leaving the iron on too long or using an iron that is too hot.
This shine, if the cloth is not scorched, can be removed by
"sponging," i. e., by placing a piece of damp muslin cloth on the
material and then applying the iron only long enough to steam the
surface of the garment.
=1289. Grease and oil stains= on white trouser stripes can be removed
|